Celestial Information

[Odan Thos]

Celestial: Prototype Human Replica Droid

~General Details~
Age: Seven years old
Hight: Five foot eleven inches
Weight: Two hundred and three pounds
Appeared Gender: Female

~Skin~
Description: The skin of this HRD is an advance carbon base plastic compound which consists of hexagonal structures which are connected on the molecular level. They are layered on top of each other creating a skin only an inch thick, but made up of ten thousand layers of hexagonal cells.
Properties: Each hexagonal structure has its own molecular markers, and when a large current is ran through the skin structure each hexagonal structure returns to its original bonds and of the resealed the gaps which may torn apart. By introducing a small voltage, the pigment will cycle through several different shades.

~Muscular~
Description: Carbon tubes created by spinning carbon fibers and bonding them with molecular tagging each fibers molecular. The tubes are connected in such a way to regulate they run from the core to the limbs and back to the core again.
Properties:Muscular movement is stimulated by use small electrical pass through the fibers constricting the thickness of the tubes while a large current well reconnected the bonds and seal gaps.

~Blood~
Description: A chemically treated water that flows throw the muscular tubes which is meant to transfer the core heat throughout the body.
Properties: The chemically treated water has a much lower freezing point and higher boiling point then most liquids. It can also be drained from the tubes and stored in the understructure if there is a threat of freezing or boiling. It transfers heat very well and helps to stimulate body temperature.

~Ocular Cover~
Description: A lens which cover the ocular sensory and moves a few centimeters underneath the skulls skin covering. The lens itself is two very thin pieces with a liquid crystal substance which is stimulated by ocular sensors behind.
Properties: When stimulated by a vary small amount electricity from the ocular sensor. This stimulates the illusion that the eye is moving and can even change the color of the eyes.

~Hair~
Description: He hair is made of woven micro carbon fibers which extend into the scull and are anchored to her understructure. The strains molecular make up in combination with the weaving of the micro fibers create a stronger then almost any material of similar thickness.
Properties: Each strain contains a color pigment that when electrical stimulated traverse several different colors. There are also few extra inches which can be extended to give extra length to help with changing her look.

~Understructure~
Description: The understructure consist of a three layer of materials which are meant to resemble human bones. At the core of the artificial bones are one and one fourth centimeter diameter Laminanium cylinders. The next layer was a two and halve centimeter layer of Mandalorian Iron. The final layer is carbon fiber weave which does not have a standard thickness but does cover all areas.
Properties: The core layer of Laminanium has the abilities to repair damage to the core of the bones and chemically bonded with the next layer. The Mandalorian Iron is extremely damage resistant and even can survive a lightsaber hit. The final layer of carbon fiber weave is multiple layers which has the duel purpose of building up the cosmic appearance of the bones and more importantly hides shields the lower layers from scans.

[Odan Thos]

Celestial: MPD Prototype Battle Droid

~General Details~
Age: Four months old
Hight: Seven feet
Weight: Three hundred and twenty seven pounds
Appeared Gender: Male

~External Armor Plates[/u]~
Description: Phrik armor plates was constructed by a Mandalorain armorsmith which are mounted on the lower frame to provide additional protection. They are built to be removed which allows access to key components under them.
Properties: The Phrik is incredible strong to the point of being lightsaber resistance. The thickness of the armor plate range from one to two inches with the chest and head being the thickest and the limbs are the thinnest.

~Understructure~
Description: The understructure of the is made of Laminanium and layers of carbon fibers. Inside of the understructure holds all the wiring and motivators of the droid. This is what all the external armor plates are mounted to and the carbon fiber used around the joints that provide the needed flexibility.
Properties: The Laminanium is known for its self-repair properties while the carbon fiber is known for its strength and flexibility. The carbon fiber provides a small protection from ion and electrical attacks. The understructure is strong enough not to break under large amounts of stress; such as picking up a Wookiee.

~Sensors~
Description: Located primarily the head of the MPD but several are spread across the body. The visor that covers the majority of the visual sensors used by the MPD and provides the best protect while still allowing the sensors to work. Other sensors are located at the tip of the fingers, spread around the out body, and mounted in the chest.
Properties: The sensor system of the MPD is one of the most advance ever constructed. It visual sensors range from the infra-red to ultra-violet wave length. The droid also has sonic sensors and an electromagnetic sensor that can fallow energy flow or be used to detected objects that have electromagnetic fields; such as droids and organics. The MPD also has a long range radar.

~Right Arm Weapon~
Description A built-in custom accelerated charged particle array gun which was constructed by a Baragwin weaponsmiths. Its design is very reliable, almost always firing. Also it was build for easily reloading of a special design energy cells through a side panel.
Properties: The ACP Array Gun is considerable larger then most weapons of this type with a barrel which is six inches in diameter. Its optional range is fifteen yards and at this distance created a pattern with has a diameter of four feet. It power cell holds ten shots.

~Left Arm Weapon~
Description: A build-in flamethrower which was build into the up part of the left-hand. It uses two fuels are a hypergolic, or burn when they come into contact with each other without an ignition source. They are stored in two tanks in the chest of the droid have flexible tubes which the fluids are pumped to the sprayer.
Properties: The flamethrower pumps out the two chemical compounds which gives the flamethrower a range of ten feet with approximately two minutes of fuel. The chemicals take several seconds to burn away completely meaning objects that come into contact with the flame well be covered with excess fuel and to burn after the jet leaves them. The final thing is the chemicals natures is that it does not need oxygen to burn because it contains its own.

[Odan Thos]

Celestial: Prototype Human Replica Droid Mark II

Age: Four Months Old

Height: 1.8 Meters

Weight: 62 Kilograms

Appeared Gender: Female

Description: The Prototype Human Replica Droid Mark II is the next generation of human replica droid being built for Celestial. After her experience with her first body and the MPD Prototype Battle Droid, she came to the conclusion that several changes needed to be made. While at first she was going to just upgrade her pervious body, she decided to create a new body from the ground up would be considerably easier.

The Mark II much like the original was design to be made primarily out of carbon but not using living components. These means that medical scans would still give Celestial away, but portable scans would read her as an unknown carbon-base life form. The Mark II droid body also sees the change from Mandalorian iron and laminanium for the bone structure to the high temperate superconductive material ultrachrome. The other changes included new sensor package, power core, and communication devices which the MPD contributed.

Construction: The skeleton of the HRD Mark II is several layers thick. It consists of an ultrachrome core two inches in diameter which is wrapped in a carbon nanotube to form a structure which resembles human bones. Inlayed into the carbon nanotube shell the digital circuits which comprise Celestial’s brain along with thousands of micro-gyros embedded in her joints and bones gave her a perfect sense of balance. The circuitry is made out rapid single flux quantum (RSFQ) electronics which uses ultrachrome as the high temperature superconductors. Using this, Celestial body has become a massive supercomputer capable of processing enormous amount of information and managing her massive program. The system can also bypass damages sections, at a slight reduction in computing power to prevent total system collapse. The final advantage is the system uses very little power meaning that Celestial does not have to give off an abnormally large power signature.

Attracted to the bones are synthetic tendons which functions exactly opposite of most organic muscle. It functions through thermal expansion of a material with a high index and quick response time. When a current is ran through the material, it heats up and extend and push the limbs. Then when the current is turned off it contracts back to its normal length. This gives her extraordinary strength. Then between the outer skin and the synthetic tendons is a layer of viscous non-electrolyte gel which both electrically insulates the internal components and gives her body that soft look of most humans. Her skin is woven carbon nanotube. It is combined with pigmentation and focus on producing a real skin feel and look about it. Almost no detail was spared in the skin; include fingerprints and where the skin tends to fold in specific areas.

Internal Components: The internal components of the Mark II are primarily made from ultrachrome for the circuitry and woven carbon nanotube as the casing. They are shaped and fitted together in order to give the appearance of humanoid organs should a portable scanner be used on her.

The Mark II utilizes a power generation system along with a battery backup. The battery back-up are simple connected Diatium power cells which are wrapped around to form the intestines. The primary power unit is a refillable electrochemical cell which is refilled by the ingestion of a chemical cocktail every few months. It does not need to produce because all the circuitry is made of RSFQ digital circuits require only the smallest amount of power.

The Mark II body integrates both an advance optical sensors and sonic sensor. The optical sensors in the eyes which see the infrared to the ultraviolet spectrum, low-light and telescopic vision while the hearing can be used as a passive listening system or as an ultrasonic mapping system. The body can also access wireless transmitter along with tap into any wireless communication.